Circuit Discussion
Seeking the Gate access
Purpose of this document
Development of an
experimental
platform to observe the gate response in copper medium.
Fractal Reference
The dimensions used in the circuit diagram below come from the active
vibrational wavelengths of Copper medium.
It is one possible layout to consider.
Diagonal Mediator
Bearden presents Floyd Sweet with a mental model, allowing him to
access the nuclear level of the atom, as a gate to control the Vacuum
of space itself.
Floyd comes back indicating the pattern on the TV trace showing the
infinity sign is important to this.
The trace pattern resembles the Jin Shin Jitsu pattern of the diagonal
mediator flow of the human body.
This is the Kundalini pattern at the first level.
It couples both sides into a dance, and regulates the balance.
Copper DM = 24.14 mm [fractal resonance]
Identification of the Elements
Cathode [-] Grid [-ac]
Anode[+ac]
What is the difference between copper, and a vacuum tube?
Vacuum Triode
A vacuum tube is fed with a
Source high
voltage DC, Cathode to Anode, and instantly responds to tiny voltage
changes on the grid.
This creates very large voltage changes on the plate [Anode], which are
180 degrees out of phase with the grid.
Thus a feedback oscillator will need two stages of vacuum tubes to
generate a positive feedback loop.
Copper
Copper medium, responds only to a
change
of voltage and currents running through it.
A change of the current on the copper, causes a 90 degree surge in the
voltage, during the
change of
current.
Response from copper is a
90 degree
Proton or nuclear response that opposes the incident change of
the Electron shell.
Thus a Copper element oscillator might need 4 stages in order to
generate a positive feedback system,
if that is even possible.
The copper atom is
Source
powered by vibration from the Aetheric medium.
Whatever is happening on the inner layers of the copper atoms, we know
that as we change the current on the electron shell,
the atoms respond with a surge of voltage that projects outwards from
the wire at 90 degrees to this current.
This is the primary unbalanced condition, where the voltage on the
electron shell runs way out of balance with the voltage on the
proton shell.
Copper reacts with a delay, now causing the Proton shell to surge
oppositely and thus trying to hold onto it's electrons tighter,
but only during a
change of the
current.
The nuclear force reacts more slowly, and then resists the change
in current until balance is restored. A counter EMF reaction.
The counter EMF reaction lags the AC waveform by 90 degrees in phase.
In copper medium voltage leads the current by 90 degrees.
If a TPU is set up correctly, this surge energy will disperse along
nodal points in the wire of equal distance apart.
As the surge happens, there can be a repercussion outwards which
can explode the wire at the nodal points.
The wire will come apart as sections of equal lengths, and this is a
vibrational response, with fixed segment length. A fractal resonance
response.
In order to observe this interaction there must be a
load on the copper, that causes
the current to surge.
A DC current will not deliver this response, and why Edisons power was
abandoned for Teslas alternating current 100 years ago.
Using Resonant Fractals
Creation of an
experimental platform,
is in order, to attempt to study how the various layers of the copper
atom actually achieve this self regulating response.
Also to determine which fractals can access the atoms, as the 3 basic
components, of the Triode Vacuum tube.
Cathode or negative charge element - Electron shell
Anode or positive charge element - Nucleon
Grid - ???
The atomic arrangement seems to set up the vacuum with the triode
turned inside out. Cathode [-] on the outside and Anode[+] on the
inside.
As Copper works more like a spring bouncing inwards and then outwards
of it's nuclear bundle, it is hard to make direct applicational
reference to the triode.
The first goal is to create an experiment platform, with elements
that couple directly to all the 6 layers of the copper atom, and then
determine this through direct measurements.
System must begin with a pulsed AC power supply and a load.
Pull off the twin vibrational elements, of each layer, for direct study
of the responses of each one and record them for all 6 layers.
The Joe Cell is another thought, for a reference.
If we start running current through the outer tube into a loaded
circuit at 180 points on the tube,
what happens on the inner tubes?
The above circuit diagram, represents three coil assemblies,
which can be setup at 90 degrees to one another, or in any other
pattern you wish to experiment with.
If the coils are set up to vibrate up, as the tube in the scope trace
section, they will take control of the electron shells as a coherent
field.
The nuclear resonances were determined using a "feel felt" system,
probably similar to how Floyd did it.
The coils were set up for Floyd by John Bedini and nothing explained
to him at all.
I believe I have a feel for the reason Floyd wanted these coils set up
this way.
It is the starting point for accessing the Gate.
If resisters are added in the current loops of the Proton and Electron
coils, now the energy in the current loops can be measured.
Next the neutron gate coil, can be set up as a rectangle loop also, or
as a scalar canceling coil.
If it is set up in the correct angular arrangement then it should
produce an effect in the other coils when very tiny currents are
stimulated in it.
All of the coils can be scalar canceling but not fully balanced. That
is the turns of each opposing winding are a different resonance fractal.
There is much experiment to be performed in this seeking of the gate
coupling. I believe it can be accomplished.
If the correct wire lengths are used.
Coupling to the nuclear bundle is vibrational.
In the deep copper scan document above, I have included a wavelength
titled the DM, or diagonal mediator for copper.
It is the vibration indicating you have balanced the regulator system
of the copper control loop on your feedback system.
I have also included some interesting ratios for each layer set of the
copper atom.
These are all feel felt resonances.
One may be able to arrive at this from current scientific charts,
however there is a real maze of these
dimensions provided as to the atoms where we are working at those sizes.