The Tube Device Duplication
Demonstrating the interactions between Proton and Electron magnetic materials and precession angles in the AG metals.
The tube device is a linear scalar magnetic device
and thus can be used to study the effects of large coherent nuclear
spin fields. It is not intended to be a device for any other useful
purpose at present, or a device you leave active and forget about.
As of yet all the experiments I have done on the tube device have used
the body and the palms to observe effects of a diamagnetic or
electric nature. While the device was originally intended for
O-scopes and magnetic wave pulses to propagate through the tubes, I
have become completely sidetracked from this original goal to study the
extreme diamagnetic and scalar effects
we have been observing. The device is generating scalar type fields
that are highly perceptible to 100 feet or more. They are also somewhat
interactive with intention.
In my first configuration the device sets up two opposing magnetic fields, each one covering a
of about 2' , using a series of tubes constructed with the
AG metal Copper and the magnetic metal Iron with a Bismuth
center placed in the area of opposition. This is a reflection of the
RainMaker 1 only adds Copper as well as large counts of AG
material atoms setting in the large magnetic fields. Alternate
tubes of Aluminum are also provided to set between the existing tubes
if desired. The tubes are 4 foot long and two
opposing fields are set up one on each end. Dual Tesla flat coils are
placed at the center and shorted together on inside and outside ends to
form a scalar canceling coil in two planes of motion. Inside tube is
centered using layers of electrical tape and the tubes do not touch.
Even without any scalar coil present very strong effects are noted.
It is thought that the long magnet strings create an isotope line that
begins to move coherently, that is, the fields acts as one magnetic
field moving through only one or two precession motions. This creates a
moving magnetic field that easily interacts with the scalar coils and
the AG metals. The AG metals are magnetically precessing through the HF
band at the Proton shell and the Iron is precessing through the
microwave bands at the Electron shell. The Copper tubes short this
field and cancel the magnetic fields. As the magnetic field is
cancelled in an atom of the Copper or Bismuth some of the
diamagnetic field is freed from its normally locked 90 degree position
Magnets are long strings of disc Neo 1/2" diameter and slide into 1/2"
copper tubbing easily. Bismuth is 10" of standard pelletts which also
fit the tube nicely. Various patterns of magnet and Bismuth pellets can
be used to show how field coherence is effected by mass of elements
present [atom count].
Another copper pipe can be slid over the iron pipe to increase the copper to iron nuclear precession coupling interaction.
All the AG metals placed around the magnetic tubes over time become
coherent [spin coupled] and begin to precess at a higher then normal
rate at the nucleus. The two fields spin opposite directions and at the center a nuclear
occurs which propagates along all the metals but
particularly the AG metals Copper and Aluminum. One gets a sense of the
unique quality of these metals. With normal magnets interacting with
only the Iron tubes, magnetism moves along the tube and drops off in a
foot or less where we see a polarity reversal with a compass and
finally very little. The energy propagating along the AG metals does
not experience this kind of loss and moves completely to the ends of
the tubes heating up the entire 4' lengths to the same constant level
The scalar coil begins to radiate a heat energy perpendicular to the
coil along the tubes, as well as conical fields expanding outwards from
the center for each precession angle. This energy will spin couple to
other tubes held in it's
field and particularly around 42.5 degrees it will propagate down
Aluminum and Copper tubes crossing it's path and extending the heat
field perception of diamagnetic properties. This effect is very
powerful and heats me up much differently then the RainMaker 1 unit. I
have no sense of "inflow" or "outflow" as is present in the cylindrical
RainMaker 1 unit, but the strong sense of 3rd eye pressure and heat at
Irregardless of magnet polarity the device seems to cause a low
pressure area around it for a great distance, as well as a radiant hot field
notable to about 100 feet that can be felt with the palms and the third eye center as strong pressure.
Aluminum Copper Interaction
Using the above device in the active mode [magnets inside] it was noted
that holding a 4' Copper or Aluminum tube at about 42 degrees with one
end laying on the iron tube the heat energy immediately radiates down
it. With a 4 foot copper tube in my right hand vertical beside me and
an Aluminum tube in my left hand crossing the device an electric sensation is felt
moving through the body that leaves the left arm tingling. With both tubes
lying on the precession angle about 1 to 2" apart a chi heat is radiated
strongly from between them and heat is constant the entire length. The effect does not decrease with distance down the tubes.
If an Aluminum tube is placed inside the device between the inner copper and the outer iron pipe the effect is lowered.
This photo is showing the dual scalar Tesla coil fitted over a layer of steel wool to preserve the magnetic flow.
The original device used a large Lakhovsky coil which was found to be
so strong that I was unable to work in the area for more then 20
minutes at a time so I altered the design to use the scalar dual Tesla
coil. 9 flat wraps of #12 wire in each side of the coil and the coil is
shorted at the center and on the outer end. This coil will easily short
out the nuclear precession frequencies in the HF bands and cancel
Proton magnetic radiations.
Each time the device had magnets inserted, and often soon after they
were removed unusually heavy rainfall was noted in downpours.
Although the field strength seems to build over about 2 days to a
constant stress pressure, removing the magnets tears down the
field very quickly to a residual spin that can be felt in the copper
for a time only at very close range.
It was also observed that unusual cloud formation would develop
centering over the building where the tube device was active. Clouds
often seen moving towards the building from all directions
simultaniously in an area that normally has a prevailing Southeast wind.
We have been studying the device for approximately 2 months and feel it
has the largest radiant field of any of the diamagnetic devices that
we have yet worked with. After attempting to control the weather
we realized that it could not be predicted exactly the effects that
would result from flipping the magnets, or the patterns. I got the most
sun with all the magnets aligned in attraction across the device and
perfectly aligned with the earths magnetic field, however even in
this mode the device throws off a rather strong field.
Sleeping off the 90 degree angle of this device even with all magnets
in attraction I observed physical arthritic pain, tension in the head
and other basic ill effects all being strongly aggravated, as well as a
pretty constant 3rd eye pressure. The only way to deactivate the tubes
seems to be to remove the magnets. Turning the device, one side
now pointing at the bed, from the next room, the effects are decreased
considerably and become tollerable.
It is commonly known that a combination of Aluminum Plexiglass and
Copper layeres may produce HV electric effects if setting in a magnetic
field that is being vibrated with a small tickler coil or a scalar
coil. I have not found the correct combination as of yet, however
adding a plexiglass tube is seen to add a certain heat feel to the mix
of the energy radiating out in the field produced.
An alternate pattern consisting of 18" of bismuth pelletts broken up
into 1" sections and dispersed through the magnet strings evenly will
produce an extremely hot series of fields the entire length of the
tubes, although it is very hard to slide the inner tube into place
because of the strong magnetic interaction with the iron tube. It was
discovered that while each of these small fields felt hotter at close
range, the overall spin field is much smaller and has little or no
weather effects observed in this arrangement. The field coherence is
definitely a function of each magnet strings length as a single
magnetic field, all atoms becomming one coherent field. Breaking up the
fields causes a loss in the coherence of the big field and a tremendous
shrinking of its' reach for linear tempic effects.
More on Coherent Nuclear Spin
Neutron Spin Coherence
10 - 10 - 06